[quote]I had the problem of BM not showing up in CCC after installing 10.3 over the top.
I tried doing a fresh install, to no avail.
I finally got it working by not only uninstalling/driver sweep, but had to manually un-install CCC and then re-install everything.
BM shows right up, and works great now. Win7 64 Ult./Radeon 5970.
(and I agree-these drivers ROCK :rockout Dirt2, for example, went up 10FPS! Far Cry 2 also saw an increase of about 8 FPS- sweet!)
Would it be possible for you to do a detailed write-up on how pulled this off? Like what monitors you're using, what your connections are? I'm using Displayport, HDMI, and DVI-D. I've been scrambling my brain for a few days now trying to get it to work. I'm running two Westinghouse 24" at 1920x1200 with a Sceptre 24" also at 1920x1200. I just cannot figure it out.
Driver Packaging Version 8.71.3-100205a-095620E
Catalyst™ Version 10.2
Provider ATI Technologies Inc.
2D Driver Version 8.01.01.1010
2D Driver File Path /REGISTRY/MACHINE/SYSTEM/ControlSet003/Control/CLASS/{4D36E968-E325-11CE-BFC1-08002BE10318}/0005
Direct3D Version 8.14.10.0735
OpenGL Version 6.14.10.9606
Catalyst™ Control Center Version 2010.0205.1306.23449
Did you have to install the 10.2; install the 10.3 over top. Uninstall manually then re-install?
No problem...
I am using 3 Dell 2209WAs, two DVI, one on the Accell active dp-dvi adaptor.
I WAS using the 10.2s . At first, I did try to install "over the top", as a lot of people said that's all you needed to do. This resulted in a weird "blackout" for a few seconds, and then it appeared all was well. But that's when I noticed the "bezel compensation" wasn't listed as an option in CCC. After un-installing and re-installing, with the same issue, I realized both times the installer would give me the "CCC is already up to date, and doesn't need to be updated". This led me to believe I needed to actually un-install CCC as well...
Sooo...I went to "Driver" page, uninstalled the ATI driver. Then, I went to programs and features and un-installed the ATI CCC and the "profiles" that were installed with 10.2. Finally, I booted into safe mode, and used driversweeper to clean out the ATI drivers completely.
THEN, I installed 10.3 preview drivers- this time, it installed CCC without the error, and BAM, bezel compensation is now in my CCC.
Hope this helps- I know it sucks bangin' your head against the wall trying to get it working. Good luck! :cheers