| Widescreen Gaming Forum http://www.wsgf.org/phpBB3/ |
|
| Issue with single monitor http://www.wsgf.org/phpBB3/viewtopic.php?f=67&t=19679 |
Page 1 of 1 |
| Author: | Doodleman [ 22 Apr 2010, 15:29 ] |
| Post subject: | Issue with single monitor |
Good morning, First of all, I am aware of the sticky regarding enabling gaming in the center monitor only. Very helpful I'm sure, but I have run into a weird problem. My setup is a digital TH2Go, connected to 2 monitors through ports 1 and 3, as recommended by Matrox, on a Win 7 64bit with a Nvidia GTX 295. Yes, 2 monitors. There are reasons for that but they are not relevant to this post. Now, I am able to get the 3840x1200 resolution going through the wizard. I can even add a single monitor 1900x1200 mode manually through the software. However, when I run the wizard to add a single screen mode, the screens goes blank at the "applying mode" step and it never completes, forcing me to reboot. If I switch to single screen mode, it runs fine in the left screen. I can then swap it to the center screen, and most of the time it also works fine. However (here comes the issue), when I try to revert back to dual head mode, the left screen stays blank. Obviously, the desktop is back to 3840x1200 because I'm missing half of the desktop, but I cannot revive the left screen at all. The only solution that works is restoring the factory default config, which deletes all of the above work. So, two issues I guess: (1) Wizard will not complete a second configuration after the initial one and (2) Once I switch to single screen mode, the left screen will not revive, despite having successfully reverted back to 3840x1200. Any ideas? |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|