Widescreen Gaming Forum http://www.wsgf.org/phpBB3/ |
|
strange question about Setup Wizard http://www.wsgf.org/phpBB3/viewtopic.php?f=67&t=18353 |
Page 1 of 1 |
Author: | dvk [ 12 Nov 2009, 18:42 ] |
Post subject: | strange question about Setup Wizard |
After startup or reboot - my monitors display on screen that I am using a DVI connection. I am using a 10 ft RoHS compliant Digital DualLink cable from computer to GXM and single link DVI cables from GXM to the monitors. After running the Setup Wizard - I see this - Is this RIGHT ? ? ? The wizard has finished retrieving information and is ready to apply the following display setup: - Digital - Connector 1: - Dell Computer Corp. Dell 2208WFP (Digital) on Analog connector. - Connector 2: - Dell Computer Corp. Dell 2208WFP (Digital) on Analog connector. - Connector 3: - Dell Computer Corp. Dell 2208WFP (Digital) on Analog connector. - Display setup: - 3 displays, stretched mode - Display mode to apply: - 1680x1050 per monitor (output refresh rate: 55Hz) Why does it show that I am using an Analog connection? The reason that I ask is that I cannot get Bezel management guidelines to X at the center of my center monitor? I am looking for any ideas that may help. thank you, David |
Author: | rostato [ 12 Nov 2009, 21:42 ] |
Post subject: | strange question about Setup Wizard |
Can't help, but mine does the same thing! |
Author: | AussieTimmeh [ 13 Nov 2009, 12:16 ] |
Post subject: | Re: strange question about Setup Wizard |
I am using a 10 ft RoHS compliant Digital DualLink cable from computer to GXM Is this the supplied cable? I know the TH2G run the short supplied cable close to or at maximum capacity, and this can be compromised by a longer length. When I am at work next I can check what my TH2G monitors report as. |
Author: | dvk [ 13 Nov 2009, 14:52 ] |
Post subject: | no it is not |
Wanted to relocate computer on floor away from monitors so I had to buy another longer cable. I temporarily moved computer back and used short 2 ft cable that came with GXM and SAME RESULTS. bezel management guide lines will not X at center of monitor but at 2/3 distance to the right. Looking at Nividia cp shows that current resolution is 5040x1050 but I am wondering what I "really" have on my monitors. If I change resolution in Matrox PD to 4320x900 I get the same results. also I do not get the correct pixel numbers at the top of the screen during bezel management. any idea to try ? - thanks |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |