Hello Slip-Stream,
Thanks for your answer!
Of course I tried it myself but everytime I plug in the Display, the widescreenresolutions in FSX is gone and the other way, the display will switch off if I plug in the matrox.
In the cabin, where the TFT display is placed, there is not much room for more displays. Also it would mean a lot of cables because the matrox is sitting on the roof/wing and the computer in or at the rear outside of the plane.
Any solution by software to tell the graphic card to clone the picture of one display port no matter what the resolutions are? May it be a possibitly to use the D-Sub-Connector on the matrox to make things easier? We had the problem with the projectors as long as we where using DVI and HDMI connectors, there where always trouble with one or two units. After we use the good old D-Sub everything is fine: perhabs the units lost some possibilities to communicate with each other... ;-)
|