Widescreen Gaming Forum

Hi all


I've just got my active DVI-DP adapter the other day, and after tinckering about with the settings, I've yet to found a solution to my problem.

I read the custom resolution guide using the Custom Resolution Utility on this forum, but I really didn't understand anything of that guide.


So anyway, my setup is the following:
CPU: AMD Phenom II X4 955BE
GPU: ASUS EAH 5850 1GB (ref design, 1st version (2009))
Display 1 (left): 22'' 16:10 Samsung SyncMaster 226BW (Native = WSXGA+)
Display 2 (middle): 20'' 4:3 Dell FP2001 (Native = UXGA)
Display 3 (right): 22'' 16:10 Samsung SyncMaster 226BW (Native = WSXGA+)


So..
My problem is that I want Display 1 and 3 (the Samsungs) to display WSXGA+, and Display 2 (Dell) to display SXGA+ (for same vertical pixel amount), but I simply cannot find a way to make my displays, display more than 4200x1050 (meaning that all three are displaying in SXGA+).

So..(again)
How do I make Display 1 and 3 show their native resolution (WSXGA+), while Display 2 is in SXGA+?


I hope I made it fairly understandable. I'm from Denmark, so bear with me, as English is only my 2nd language.


Thanks in advance!
Best Regards, Frederik.

Well... you cant. You may be able to get the SXGA+ monitor to run WSXGA+ so that all your screens will run WSXGA+, but you cant have mixed resolutions like that with eyefinity.
You may want to try SoftTH and the SoftTH Configurer. This would allow you to run DX9 Games in an SLS mode, but it's not nearly as good as Eyefinity.

_________________
System Core: | Intel Core i5-2500K + ASUS P8Z68-V + 16GB Corsair XMS3 DDR3 1333 MHz | Win7 x64 | MSI R7970 Lightning 3GB [1105/1400] |
Display: | 3 x Dell Ultrasharp 3007WFP-HC @ 7680x1600 | Dell u3011 |