Widescreen Gaming Forum
http://www.wsgf.org/phpBB3/

Eyefinity grouped resolution lower than native
http://www.wsgf.org/phpBB3/viewtopic.php?f=66&t=22053
Page 1 of 1

Author:  xoroku [ 22 May 2011, 12:44 ]
Post subject:  Eyefinity grouped resolution lower than native

I'm using 3 Asus VH242H, an XFX 6950(reference model) with drivers 11.5a and a Sapphire MDP to S-Link DVI adapter.
2 monitors are connected with DVI and 1 with the adapter.

The adapter doesn't recognize my monitor and defaults it to "Generic Non-PNP Monitor".
To fix this I have plugged the monitor in DVI and retrieved it's information with Moninfo by extracting it's driver(.INF).
I then reconnected the monitor with the adapter and replaced the default driver with the one created using MonInfo.
I can now select the proper resolutions and refresh rates but when I create an Eyefinity group, the maximum grouped resolution is 4800x900 instead of 5760x1080.
In CCC the monitor concerned is still listed as "Unknown" which I presume would be the cause.

I've searched a lot on different forums and most issues people seem to have relate to bezel compensation and flickering caused by adapters.

Author:  Paradigm Shifter [ 22 May 2011, 16:38 ]
Post subject:  Re: Eyefinity grouped resolution lower than native

Reply in this thread:

http://www.widescreengamingforum.com/forum/viewtopic.php?f=64&t=23508

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/